With the release of the call for "low-carbon, environment-friendly and green travel", more and more people choose to travel by bus. This phenomenon has promoted the rapid development of the bus shelter industry. To meet the practicability of bus stops and the characteristics of low carbon and environmental protection, bus stop shelter manufacturers have racked their brains. Research and develop different materials to meet the requirements of low-carbon and environmental protection! With the increase of material types in the market, the selection range of ceiling materials for bus shelters is becoming wider and wider. So, as a bus stop customer, how do you choose a bus stop ceiling suitable for your use? The manufacturer of stainless steel bus shelter said:

There are generally several types of suspended ceilings of bus stop waiting for booths: galvanized sheet, sunlight sheet, PC endurance plate, stainless steel plate, etc. In general, bus stops use stainless steel suspended ceilings. 201 stainless steel plate and 304 stainless steel plate are two kinds of common stainless steel waiting booths. The characteristics of suspended ceilings of bus stops waiting for booths are high-temperature resistance, high toughness, durability, and good processing performance. For some tropical cities, it is recommended to use stainless steel plates as the ceiling of bus stops.

The characteristics of the suspended ceiling of the bus shelter with solar panels are relatively light, UV resistant, and impact-bearing. The suspended ceiling made of this material is suitable for coastal cities with severe UV radiation. It can not only protect the skin from UV radiation but also prevent the skin from being burnt by UV radiation.

The galvanized bus station shelter roof is characterized by strong corrosion resistance, durability, and long service life. The rainproof roof of stainless steel shelter manufacturers applies to cities or regions with a long replacement cycles of bus stops. PC endurance board is a kind of common ceiling material for bus stations waiting for booths. Generally, it is sufficient to control the ceiling thickness between 6-8mm. PC endurance board is characterized by convenient processing and good lighting. However, the PC endurance board is easy to be affected by the temperature difference, and its surface adhesion is strong, so it is difficult to clean later.

The above points are the recommendations of the bus shelter manufacturer for the selection of bus platform ceilings.