As a professional bus shelter manufacturer, Foshan Yilong not only provides customers with high-quality products, but also pays attention to high-quality after-sales service to meet customer needs as the criterion for success. The following will introduce the knowledge related to the installation of bus shelters in after-sales management:

1. Select the location where the shelter needs to be installed

The installation location of the bus shelter should not occupy the blind lane, and the distance between the two bus stops should not be too close.

2. Remove the surface layer of the original road

If the original pavement is marble or floor tiles, it needs to be removed one by one. If the original pavement is a cement pavement, the cement pavement layer within the area where the shelter is installed needs to be removed to expose the original soil surface.

3. Dig out the corresponding foundation soil pit according to the size of the bus shelter

According to the size of the bus shelter, a pit with a depth of about one meter was dug, poured into a square column with reinforced concrete, and exposed bolts to facilitate fixing the base of the shelter. Thread the power cord of the shelter with high-quality plastic tubing.

4. Fix the base of the bus shelter with the bolts on the square column

When fixing, be sure to tighten it firmly. Install the plastic tube.

5. Lay the original floor tiles or marble surfaces.

6. Remove the rubbish generated by construction and installation.

The installation steps of the bus station are as follows. If there is any incomprehension, in the project, Yilong will also arrange professional engineers to guide the installation on site, and work with customers to complete the entire project better and more effectively.